Measuring Guide

How to Measure for a Dehner Boot

Getting the measurements right is critical for a great fitting boot! Before measuring, figure out what kind of boot you want and how you will use them. Ask yourself the following questions:

  1. Do you do most of your riding in the morning or evening? Do your measuring during that time. (some peoples feet swell later in the day).
  2. Do your feet retain water (common in women) during any particular time of the month? If so, please measure your feet accordingly.
  3. Do you have any foot problems like bunions, swelling, corns, calluses, or any bones in the foot or ankle that have been broken in the past? Please note this in the remarks area of the order form.

DO NOT MEASURE YOURSELF! Whenever possible always have a friend for family member measure for you as this will produce much more accurate results.

It is also preferable to take the measurements over breeches and socks to be worn while wearing the boots. If you must measure over a bare leg, indicate this on the form.

* ALL MEASURES ARE CIRCUMFIRENCE MEASURES. ALL THE WAY AROUND THE FOOT

Measuring Instructions

While standing, trace each foot outline on the form, with equal weight on both feet. Be sure to hold the pen (or pencil) perpendicular to the paper – or the tracing won’t be accurate.

First measure the ball of the foot (from the big toe joint over the little toe joint) with a tape measure. Pull the tape snug, but not too tight, and measure to the nearest 1/8th inch.

Second is the waist, the narrowest part behind the ball of the foot.

Step 4A

Third is the instep measurement. This is the highest point of the top of the foot. Slide your finger along the outside of the foot until you come to a small bone that sticks out.

Step 4B

Wrap the tape around the foot at that point (snug, not tight) and record the measurement.

The heel measurement is taken diagonally at the widest point. from the back of the foot to where the front of the leg meets the top of the foot. Make sure the sock is not bunched up.

The calf measurement is taken at the widest point of the calf. Slide the tape up and down to find this spot.

Step 7A

To measure the boot top, with your fingers, find the point on the inside where the knee bone comes out.

Step 7B

With the leg held straight up and down, wrap the tape under the bone and straight across.

Measure the boot height with the tape, from the point under the knee bone. Hold the tape in place at the top and bring it down to the floor (avoid a sagging or drooping tapes). Then add at least 1 1/4 inch to this measurement to take care of wrinkling in the ankle (a cuff lining might require more, a dressage lining might need less).

*Please Note: If you are measuring for a patrol boot, this step does not apply.

Ok, You’re Done!

Please keep the following things in mind when filling out the order form:

  • Remember to fill out the form completely!!
  • Little things that you might think are not important are very important to us. Be especially careful in filling out the shoe size, height and weight boxes. These are helpful to us to double check your measurements.
  • Lets say you have filled in a height of 6’ and a boot height of 16 3/4”, we would assume that the boots will be too short, and would call you to check this measure again. The same with the foot size and the weight.
  • Please keep in mind than any boot that measures 21″ or higher in the leg will be charged an additional $90.00. This doesn’t happen often but can if you are larger in stature.
  • We would prefer all orders are returned to us by regular mail. You “may” send us your order via fax, however this process may distort the foot outlines. The use of e-mail is not advised at this time. This process also distorts the foot outlines.

So that’s all there is to it! If you have any questions, don’t hesitate to call for assistance during regular business hours.

Copyright © 2021 The Dehner Company, Inc. Made Proudly in the U.S.A. | Website Design by Tomo360.